3.2mx38mm Self adhesive Waterproof Sink Bath Sealing Corner Strip Tape PVC for Bathroom Kitchen

Corrosion resistance, high-temperature resistance, wear resistance, effectively damp-proof, mildew-proof, easy to scrub.

Application: kitchen stove, dishwashing, corner sealing between ceramic tile and wall.1. Thoroughly remove the original silicone sealant with the knife.

Use organic solvents (thinner), such as rubber water, gasoline, etc., to clear the surface residue.

The surface is completely dry.

Installation indoor temperature is better around 25 degree Celsius, too cold place can be heated by electric hair dryer viscose, then paste.

Remove the plastic film on the back of, fold it to 90 degrees, and paste it on the bathtub and the wall surface.

90 degrees turn when the corner of the paste, the docking side should be cut into 45 degrees to the interface.

After compaction, 8 hours to 10 hours later can be used.1. Thoroughly remove the original silicone sealant with the knife.

Use organic solvents (thinner), such as rubber water, gasoline, etc., to clear the surface residue.

The surface is completely dry.

Installation indoor temperature is better around 25 degrees Celsius, too cold place can be heated by electric hair dryer viscose, then paste.

Remove the plastic film on the back, fold it to 90 degrees, and paste it on the bathtub and the wall surface.

90 degrees turn when the corner of the paste, the docking side should be cut into 45 degrees to the interface.

After compaction, 8 hours to 10 hours later can be used.1. Thoroughly remove the original silicone sealant with the knife.

Use organic solvents (thinner), such as rubber water, gasoline, etc., to clear the surface residue.

The surface is completely dry.

Installation indoor temperature is better around 25 degree Celsius, too cold place can be heated by electric hair dryer viscose, then paste.

Remove the plastic film on the back of, fold it to 90 degrees, and paste it on the bathtub and the wall surface.

90 degrees turn when the corner of the paste, the docking side should be cut into 45 degrees to the interface.

After compaction, 8 hours to 10 hours later can be used.1. Thoroughly remove the original silicone sealant with the knife.

Use organic solvents (thinner), such as rubber water, gasoline, etc., to clear the surface residue.

3. The surface is completely dry.

4. Installation indoor temperature is better around 25 degree Celsius, too cold place can be heated by electric hair dryer viscose, then paste.

5. Remove the plastic film on the back of, fold it to 90 degrees, and paste it on the bathtub and the wall surface.

6. 90 degrees turn when the corner of the paste, the docking side should be cut into 45 degrees to the interface.

7. After compaction, 8 hours to 10 hours later can be used.